Morton M340012 Bedienerhandbuch PDF herunterladen (Seite 14)

14 Morton

System Saver

Installation & Operation Manual

Your Morton Water Softener has a “High

Efficiency” feature with an ON or OFF setting.

This softener setting is shipped in the OFF posi-

tion, which utilizes the maximum rated capacity

while most often achieving maximum salt effi-

ciencies. When installing this unit in the State of

California, you MUST turn this setting to the ON

position, which may initiate more frequent

recharges. However it will operate at 4000

grains per pound of salt or higher.

If you wish to turn the Salt Efficiency feature ON

( icon will show in the display), follow the

instructions on this page.

Questions? Call Toll Free 1-888-64 WATER (1-888-649-2837) Monday- Friday, 8 AM - 7 PM EST

or visit www.systemsaver.com

When you call, please be prepared to provide the model and serial number,

found on the rating decal, located on the rim below the salt lid hinges.

2. If you want to change the recharge start time,

press the

UP or

DOWN buttons until the

desired time shows. Be sure AM or PM is correct.

3. Press the SELECT button once more to complete

the initial programming. The current time of day

will show in the display.

Step 4. Set Salt Efficiency

When this feature is ON, the water softener will oper-

ate at salt efficiencies of 4000 grains of hardness per

pound of salt or higher (May recharge more often

using smaller salt dosage but more regeneration

water). The softener is shipped with this feature set

OFF.

1. Press and hold the SELECT button until one of the

screens in Figure 20 is displayed. Once in this dis-

play, press the SELECT button once and one of

the two displays in Figure 21 is shown.

Step 3. Set Recharge (Regeneration)

Time

Your demand water softener will automatically regen-

erate when it needs to, based on water usage. The

time of day that the automatic recharge cycle begins

may be changed as follows:

1. Press the SELECT button once again to display a

flashing “2:00AM” and the words “RECHARGE

TIME”. This is a good time for the recharge to start

in most households, because water is not in use.

FIG. 19

2. Press the

UP or

DOWN buttons to set ON or

OFF. When set to ON, the efficiency icon will be

displayed in the upper right hand corner of the nor-

mal run display.

FIG. 22

FIG. 20

FIG. 21

Efficiency Icon

3. Press the SELECT button three times, to return to

the normal run display (See Figure 22).

Displayed when efficiency

is set to “ON”

California Efficiency Requirement

Programming the Water Softener

(Models M20, M27 & M30)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare

Morton M340012 Bedienerhandbuch Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserspender Morton M340012