Morton M340012 Bedienerhandbuch PDF herunterladen (Seite 16)

When the power supply is plugged into the electrical

outlet, a model code and a test number (example:

J2.0), begin to flash in the faceplate display. Then,

“12:00 PM” and the words “SET TIME" begin to flash.

NOTE: If “- - - -” shows in the display, press the

UP or

DOWN button until the model code

(“o20” for Model M20, “o27” for Model M27,

“o30” for Model M30 or “o34” for Model M34)

shows in the display. Then, press the

SELECT button to set, and change to the

flashing “SET TIME" display.

Step 1. Set Time of Day

If the words “SET TIME" do not show in the display,

press the SELECT button until they do.

1. Press the

UP or

DOWN buttons to set the

present time. Up moves the display ahead; down

sets the time back. Be sure AM or PM is correct.

2. If you want to change the recharge start time,

press the

UP or

DOWN buttons until the

desired time shows. Be sure AM or PM is correct.

Step 3. Set Recharge (Regeneration)

Time

FIG. 31

16 Morton

System Saver

Installation & Operation Manual

Programming the Water Softener

(Model M34)

FIG. 28

NOTE: Press buttons and quickly release to slowly

advance the display. Hold the buttons down

for fast advance.

Step 2. Set Water Hardness Number

1. Press the SELECT button once again to display a

flashing “25” and the words “SET HARDNESS”.

2. Press the

UP or

DOWN buttons to set your

water’s hardness number.

NOTE: If your water supply contains iron, compen-

sate for it by adding to the water hardness

number. For example, assume your water is

20 gpg hard and contains 2 ppm iron. Add 5

to the hardness number for each 1 ppm of

iron. In this example, you would use 30 for

your hardness number.

20 gpg hardness

2 ppm iron x 5 = 10 +10

(times) 30 HARDNESS NUMBER

FIG. 30

Your demand water softener will automatically regener-

ate when it needs to, based on water usage. The time

of day that the automatic recharge cycle begins may

be changed as follows:

1. Press the SELECT button once again to display a

flashing “2:00AM” and the words “SET RECHARGE

TIME”. This is a good time for the recharge to start

in most households, because water is not in use.

FIG. 29

Low Salt LED Indicator

Display

SELECT button

DOWN button

RECHARGE button

UP button

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare

Morton M340012 Bedienerhandbuch Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserspender Morton M340012