Morton M340012 Bedienerhandbuch PDF herunterladen (Seite 17)

Morton

System Saver

Installation & Operation Manual 17

FIG. 33

2. Press the

UP or

DOWN buttons to set ON or

OFF. When set to ON, the efficiency icon will be

displayed on the right hand side of the normal run

display.

FIG. 34

Efficiency Icon

3. Press the SELECT button three times, to return to

the normal run display (See Figure 35).

FIG. 35

Displayed when efficiency

is set to “ON”

Your Morton Water Softener has a “High

Efficiency” feature with an ON or OFF setting.

This softener setting is shipped in the OFF posi-

tion, which utilizes the maximum rated capacity

while most often achieving maximum salt effi-

ciencies. When installing this unit in the State of

California, you MUST turn this setting to the ON

position, which may initiate more frequent

recharges. However it will operate at 4000

grains per pound of salt or higher.

If you wish to turn the Salt Efficiency feature ON

( icon will show in the display), follow the

instructions on this page.

California Efficiency Requirement

Questions? Call Toll Free 1-888-64 WATER (1-888-649-2837)

Monday- Friday, 8 AM - 7 PM EST

or visit www.systemsaver.com

When you call, please be prepared to provide the model and serial number,

found on the rating decal, located on the rim below the salt lid hinges.

Programming the Water Softener

(Model M34)

Step 4. Set Salt Level

The water softener has a low salt indicator light to

remind you to refill the storage tank with salt.

NOTE: You must set salt level each time salt is added

to the water softener.

To set this monitor system:

1. Lift the salt lid and level the salt in the storage tank.

2. The salt level scale, on the brinewell inside the

tank, has numbers from 0 to 8 (See Fig. 32).

Observe the highest number the leveled salt is at,

or closest to.

FIG. 32

3. Press the SELECT button to display the words

“SET SALT LEVEL”.

4. Press the

UP or

DOWN buttons to set the salt

level to match the number on the brinewell. At

level 2 or below, the “Low Salt" indicator light will

flash. If you wish to turn this feature off, press the

DOWN button past 0, and the word “OFF” flash-

es in the display.

5. Press the SELECT button once more to complete

the initial programming. The current time of day

will show in the display.

Step 5. Set Salt Efficiency

When this feature is ON, the water softener will oper-

ate at salt efficiencies of 4000 grains of hardness per

pound of salt or higher (May recharge more often

using smaller salt dosage but more regeneration

water). The softener is shipped with this feature set

OFF.

1. Press and hold the SELECT button until one of the

screens in Figure 33 is displayed. Once in this dis-

LEVEL

SALT

Salt

Level

Brine-

well

Num -

bers

play, press the SELECT button once and one of

the two displays in Figure 34 is shown.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare

Morton M340012 Bedienerhandbuch Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserspender Morton M340012